Thanks works perfectly, Its not generally a problem for me IF im am operating one band at a time, like in a sprint, but when i have to jump all over the bands this becomes annoying,
just happen to read the reply you sent MONTHS ago!

Thank you for your reply, much appreciated!

73's stu ve2xx

I noticed when i use my Hermes with Thetis for transverter IF , i often go from one band to another following contest contacts ect. Say i am on 144.200, i change band to 432.100 and want to go back to 2m to the same 2 m previous freq. the freq goes back to 144.250 and not .200 Am i missing something...

i changed ONE parameter, on the 40M band from 7.125 to 7.040 and the GUI comes up out of band NOW,

must be something else to change as well,

oh well , was worth a try

Stu

Tnx Scott, found the lines in the xml " Bandtext" i will have a look at it later and see what i can do. this is just a sample i took for 40M band, Thanks for the suggestion 73's stu <BandText> <Low>7</Low> <High>7.029999</High> <Name>40M CW</Name> <TX>true</TX> </BandText> <BandText> <Low>...

is there a way to modify or add a specific band plan? in the drop down menu the Canadian band plan is not there. My N3fjp logging pgm poles freq and select the mode according to the band plan automatically. I have it turned off because i was using the US band plan and as soon as i went below say 7.1...

I reset DB and now W11 works w V 3.4.9 as well as Thesis, It was a socket error which kept popping up, nothing like opening and closing the hood once in a while to do a reset!

73's stu

hmmm, maybe i should unistall and reinstall 3.4.9 as i did an upgrade from w10 to 11 it gave me a while bunch of errors when i tried to get 349 going

Thanks

Stu

Most IF 's are for 28 your transverter should do 28IF in , 144 out, at least that's what i have. I use a similar setup with an antique MMT transverter 28 to 144 then 144 to 3456 , the only thing that is sometimes strange is that the GUI will not take anything above 2500mhz, i dont bother i set the b...

I tried using w11 with 3.4.9

it didn't work for me , went to Thesis and its fine,

I wanted to test it and see on a laptop before i upgraded other pc's

Did anyone get different results??

Tks

Stu

Crikey! Faced issue this am , some W10 update, wiped out my Xml file, Originally was using a 100D as an IF now i using a Hermes specifically set up for 28 meg IF , oddly enough if the SW was used on the 100D and you used the Hermes after it would gladly use the 2000MHZ set up in the gui like when go...

Steve, i presume the board you have is the Orion II board?? I have the schematics, if you want them,basically u need a micro coax jumper jumper between j32 and J31 this will allow use of the transverter port rx/tx, as you want , using the single connector. I use separate ports for my transverters so...